WearSpray™ 2000
Wear-Con Densit® WearSpray™ 2000 Chemically Bonded Corundum-Ceramic wear resistant lining is a sprayable, trowellable one-component ready-mix wear compound, allowing for fast monolithic coverage over large surface areas and system components with complex geometric shapes. Along with the flexibility of multi-dimensional coverage with seamless thickness graduation, WearSpray™ 2000 is fast and easy to install and can be used after just 24 hours.
Frequently viewed resources
For industrial/occupational use only. Not for consumer sale or use.
Details
Installation
Wear-Con Densit® WearSpray™ 2000 can be installed in five simple steps:
- Install mesh. WearSpray™ 2000 should be installed on a standard expanded metal mesh welded on the steel casing.
- Mix dry WearSpray™ 2000 compound for 1 minute with a paddle mixer. Product must be kept completely dry until used.
- Add water and fibers, then mix for 8 minutes with a paddle mixer. A significant change in consistency of the material (from a dry powder to wet mortar) must be observed within 3 minutes from addition of water.
- Convey mixed WearSpray™ 2000 through recommended pump, then spray onto mesh. Smooth surface if needed. Avoid making contact with aluminum or galvanized steel when using WearSpray™ 2000.
- Apply Densit® Curing Compound. For more details refer to the “Densit® WearSpray™ Video”.
Technical Specifications
Wear-Con Densit® WearSpray™ 2000 is a high-strength wear compound combined with corundum aggregates to provide excellent protection against moderate wear at temperatures up to 750°F
Sizes
Wear-Con Densit® WearSpray™ 2000 is delivered in 55 lb bags.
